A plumbing problem that frequently occurs is the sink issues. It is not fun and may cause a lot of damage. We might experience it the most at kitchen sink where we mainly use the water activities. Having a leak within the kitchen sink is an annoying experience, since it hampered the purposes of the kitchen.

However, these leaks can be easy enough for you to repair by yourself, or else it may become a nightmare for you, due to its complexions and special equipment it needed. Sometimes the minor issues are indicating major issues within the plumbing.

Therefore, while some leaking sink may be easy to fix, other which you cannot handle on your own, may require a help from the expert Plumber Sydney. They have years of experience in dealing with plumbing issues, therefore they usually had a comprehensive understanding on the plumbing system. They will certainly know the most effective method to fix your plumbing problems and ensure that the problem will not come back again in the long run.

What cause the leaking sink?

·         Drain Drip

The pipes could be the reason why the sink is leaking. A drain usually wrapped with plumber’s mud to prevent the possible future leaks. However, the mud can be too thin or it might dry out over time. To recognize where the drip is arising from, you can just plug the sink with pipes cover and fill it fully, then unplug it.

 

·         Leaking tap 

The dripping water from the tap is easy to spot because it’s visible. The indication is if you see the water ponds on top of the sink whenever someone turns the taps on. Some leaking tap may run underneath the sink, which means you need to spot it by look under the counter.

 

·         Broken O-ring

O-ring is a stick screw that holds the faucet handle in place. This is a common issue of why the sink is getting leaks. The longer the time, the more the O-ring is getting loose due to the regular use where caused the faucet to leak near the handle.

 

How to fix it?

 

1.      Prepare the tools. You’ll mainly need hand gloves, a bucket, a flat-headed screwdriver, an adaptable spanner and a kitchen towel.

2.      Find the leaking source. Check all the pipes that connect to the sink to recognize the dripping waters source.

3.      Squeeze up the waste pipe. Just squeeze up the pipe with your hand to figure out the compression fittings.

4.      Squeeze up the water feeds. The hot and cold-water pipes should have been squeezed by using an adaptable spanner. Don’t use too much effort to lessen up the damage.

5.      Test the plughole. In case the pipe fixtures have been tight enough but you’ve still seen a leaking sink, you need to be aware because the problem source may be the plughole itself. You need to plug it in the sink and fill it with cold water.

6.      Remove the trap. Place the bucket beneath the waste pipe then unscrew the compression fittings carefully so you could take down the trap.

7.      Remove the plughole. Carefully get the screwdriver inside the plughole cover to find the screw. Grip the plughole with one hand and unscrew it from the sink.

8.      Clean the plughole part. Use your kitchen tower to clean up the dirtiness around the plughole.

9.      Place the sink back. Now rearrange it into the first place. Tighten it up with the screw.

10.  Test your sink. Congratulations you have managed to fix the sink!

Content Provided By Valworx